Dashboard Gauges Work, Graph and MQTT Stop Working Minutes to Hours after Reboot
Posted: Sun Dec 24, 2023 5:39 pm
I am consistently getting "Major Setback! I've Lost Contact with the Solar Controller. Verify Integrity of Communication Cable."
Things had been working up until 3-4 months ago.
When the issue occurs, the gauges still update live as normal, but the graph is blank, the log to SD is not updating, and MQTT is not firing.
It usually takes several software reboots to get it to start working again. It will continue to run properly for a few minutes, to hours, or not at all and I give up rebooting. There have been no changes to the deployment since the last issue I had in February 2023 that was resolved be switching to edge, and allowing an update from 5.0-0dc546-2023-01-22-20-34 to 6.1-3360eb-2023-03-07-03-57.
I have since switched back to stable, hoping there is a new firmware that resolves this as well.
Things had been working up until 3-4 months ago.
When the issue occurs, the gauges still update live as normal, but the graph is blank, the log to SD is not updating, and MQTT is not firing.
It usually takes several software reboots to get it to start working again. It will continue to run properly for a few minutes, to hours, or not at all and I give up rebooting. There have been no changes to the deployment since the last issue I had in February 2023 that was resolved be switching to edge, and allowing an update from 5.0-0dc546-2023-01-22-20-34 to 6.1-3360eb-2023-03-07-03-57.
I have since switched back to stable, hoping there is a new firmware that resolves this as well.